TechniSat Technirouter 5/1x8 K-R SAT multiswitch Inputs (multiswitches): 5 (4 SAT/1 terrestrial) No of participants: 8
The digital single cable solution without program restriction!The TECHNIROUTER is a single-cable solution without a new cable! For the first time there is a one-cable solution without program restriction. There was never before! Existing cable structures in residential buildings can be upgraded with digital satellite signals from a satellite position without the need for new cables.WAS must be observed?Existing cans, distributors and amplifiers must be replaced with SAT-compatible components. Please note that all the components have a DC bypass and that the through-sockets in particular have two DC bypass-passes. The DC pass-through is required for transporting the DiSEqC signal. The 13/18 V of the receiver are not needed as a switching command, but instead to transport the DiSEqC-commands up to THE TECHNIROUTER. Naturally the existing coaxial cable must also be checked for its satellite compatibility.How does the control system work?The TECHNIROUTER-enabled receivers control THE TECHNIROUTER basic unit and cascade digitally via DiSEqC-level 1.0 with the protocol EN 50494. This protocol initiates and executes the selection of the transponder frequencies/programs in THE TECHNIROUTER. The TECHNIROUTER generates eight generated output frequencies in the ZF frequency range 950-2150 MHz, over which individual subscribers can receive all digital programs without restriction. Low and high bands can be received.How many subscribers can be served?Up to eight subscribers can be controlled per TECHNIROUTER. If eight connections are insufficient, further cascades can be connected to the base unit.If even more subscriber connections are needed, or a combination with multi-switch (star wiring) is desired, this can be combined by using multi-switches of the 5 or 9 series, as well as their accessories such as amplifiers, distributors or splitters.Which LNB is required and how is it supplied with power?Normal Quatro LNBs can be used. The TECHNIROUTER base unit supplies the operating voltage for the Quatro-LNB and also for the eventually upstream cascade.Reverse channel-fitness included!The terrestrial signal path of THE TECHNIROUTER from this family is designed from the outset for the transmission of the return signals, so that the TECHNIROUTERS can be used as part of the transmission path between the home transfer point (HUP) of the cable network operator and the cable modem of the end customer. Even if the advantages of the satellite reception are used for the TV reception by means of SCR-single cable system, they enable the simultaneous use of the already laid coaxial cable also for Internet access and telephone via broadband cable, without having to install additional feed-in frequency switches. For this purpose, the terrestrial input of THE TECHNIROUTER is usually connected to the HUeP.This text is machine translated.