FSR14SSR Eltako RS485 Actuator 2-channel DIN rail
Surge current switching relay noiseless with 2 channels, 400W. 2 Solid-State relays are not potential-free. Bidirectional. Stand-by loss only 0.1 watt. Connection to the Eltako RS485 bus. Cross-wiring bus and power supply with jumper. If both relays of the FSR14 are switched on, 0.4W is required. The nominal switching power of 400W is valid for one contact and also as the sum of both contacts. The parallel connection of several devices for increased power is permitted. From production week 12/17 with automatic electronic overtemperature shut-off. If the load is less than 1W, a BLE must be connected in parallel to the load. If the supply voltage fails, it is switched off in a defined way. The channels can be taught in independantly of each other as A SINGLE AND/or SINGLE channel. Scene control: With one of the four control signals of a button programd as scene button with double rocker, several channels of one or more FSR14SSR can be switched on or off for each scene. Central commands on the PC are sent with the building radio visualization and control software GFVS. To do this, teach in one or more FSR14SSR on the PC. The rotary switches are used to teach in the buttons and, if necessary, to test the 2 channels. For normal operation, the middle and lower rotary switches are then set to AUTO. With the upper rotary switch, the EW time (0-120 seconds) for relays or the RV time (0-120 minutes) for surge current switches may be set for all channels. If radio motion brightness sensors FBH (master) and / or FBH (slave) are taught in, the upper rotary switch, for each channel separately, is used to determine the switching threshold at which the lighting switches on or off. Settings of the upper rotary switch according to the operating instructions. If FAH60 wireless brightness sensors are taught in, the upper rotary switch, separated for each channel, determines the switching threshold at which the lighting switches on or off depending on the brightness (from approx. 0 lux in position 0 to approx. 50lux in position 120). A hysteresis of approx. 300lux between switching on and off is fixed Âeingestellt. An additional RV time set is not observed. Only one FBH (master) or FAH can be taught in per channel. However, a FBH (master) or FAH can be taught in to several channels.This text is machine translated.