FDT55EB-pg Eltako Wireless Rotary switch Flush mount Max range (open field) 30 m
1-channel wireless rotary switch, flat, for single mounting 80x8x11/9mm over a switch box or mounting in the E-Design55 switch system. With battery (service life 2-8 years). Smart home sensor The delivery package includes a retaining plate with locking-in electronics, a frame R and a front plate with rotary knob. With this wireless rotary switch all Eltako wireless dimming actuators and from KW 03/2017, the radio switching actors FSR 61 and TF61L and TF100L can be controlled comfortably. The rotary button sends direct dimming values (brightness values) to the dimming actuator. If you switch off with the rotary switch, the current dimming value is saved in this memory. If several buttons are taught in a dimming actuator and dimmed in turn, the brightness changes may occur due to the different dimming values. To memorize the radio button in the actuators, the front plate with a knob is removed, the thereby accessible mini-button (LRN) is held down and pressed briefly on the axis of the knob. The learning position to be set previously is according to the operating instructions of the respective actuator. Two internal 3V button cells CR1632 take over the power supply for several years. To replace the button cells, you simply have to remove the front plate with the knob. Installation only on a flat surface: Screw on holding plate. Then snap the frame into place, pull out the battery insulation, place the knob and snap the front plate into place. The sleeves in the box are used for screw fastening over a 55 mm switch box. We recommend using stainless steel counter-sunk screws 2.9x25mm, DIN 7982 C. Both with 5x25mm plugs as well as on 55mm switch boxes. 2 stainless steel countersunk screws 2.9x25mm and 5x25mm plugs are included in the delivery. The minimum brightness can be adjusted in 3 stages using a jumper. Similarly, the function Soft-On can be selected, whereby the lighting is soft switched on. In the middle of the rotary knob, press to switch on with the last saved dimming value and to switch off and save the current dimming value. The wireless switching actuators FSR61, TF61L and TF100 can be switched on and off by pressing or rotating. Turn it clockwise to the right to dim it up. The rotation speed determines the dimming speed. If the dimming actuator was switched off to the right at the start of turning, it is switched on at the minimum brightness and then further dimmed. This is the kids room service. If turned abruptly to the right - with the actuator already on or off - the dimming up quickly to the full brightness. This corresponds to the double-click function of normal direction button on the top. Turn left anticlockwise to dim down until the minimum brightness set on the dimming actuator is reached. The rotation speed determines the dimming speed. If you turn anticlockwise in a jerk, the brightness set on the dimming actuator is quickly dimmed. If the dimming actuator was switched off to the left at the start of turning, the light is switched on at the minimum level and then further dimmed by turning it to the right. To replace the CR1632 button cells, simply remove the cover plate with the rotary knob. The radio sensor can be taught-in to the following actuators and the building radio visualization and control software: FRGBW71L, FSG14, FSG71, FSR61, FUD14, FUD61, FUD71, TF61D, TF100D, TF61L TF100LThis text is machine translated.