Eltako 61100800 DIN-rail dimmer Blue
1-10V control dimming switch 1-10V for electronic ballast. 1 NO non-potential free 600VA and 1-10V control output 40mA. Stand-by loss only 1 watt. Adjustable dimming speed. With children's room and snooze switch. With button or switch control. For panel mounting. 45mm long, 45mm wide, 33mm deep. Switching in zero crossing for contact protection. Also for controlling LED converters with passive 1-10V interface without auxiliary voltage up to 0.6mA. Above with auxiliary voltage. Switching and control voltage 230V. The latest hybrid technology combines the advantages of wear-free electronic control with high power from special relays. The load is switched on and off with a bistable relay at the output ECG. Switching capacity of fluorescent lamps or LV halogen lamps with EVG 600VA. By using a bistable relay, there is no coil power loss and no heating thereby even when the relay is switched on. After installation, wait for the automatic short synchronization before connecting the switched consumer to the mains. Short control commands switch on / off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the dimming direction. The set brightness level remains saved when the device is switched off. In the event of a power failure, the switching position and the brightness level are saved and, if necessary, switched on when the supply voltage returns. The dimming speed can be set with the dim speed rotary switch (only when activated with a button). If light switches cannot be replaced by light switches, the rotary switch can be set to the switch symbol at the right stop: If the closed switch is opened again briefly, then it is dimmed until it is opened again briefly. The dimming direction is changed automatically at the two vertices. In addition, the direction can be changed by briefly opening the switch twice. With children's room switch (only for activation with button): When switched on with longer button activation, the light is switched on at the lowest brightness after approx. 1 second and, as long as it is still being scanned, slowly dimmed up without changing the last brightness level saved. With snooze function (only for activation with button): By a double pulse, the lighting is dimmed from the current dimming position up to the minimum brightness and switched off. The max. dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. By means of short buttons, you can switch off at any time during the dimming process. A long button during the dimming process dims up and ends the snooze function.This text is machine translated.