Eltako 21100810 DIN-rail dimmer
Universal dimming switch with rotary knob, power MOSFET up to 800W. Automatic lamp detection. Stand-by loss only 0.2 watt. Minimum brightness and maximum brightness can be set. Series installation device for mounting on DIN-EN 60715 TH35 mounting rail. 2 division units = 36mm wide, 58mm deep. Universal dimming switch for lamps up to 800W, depending on the ventilation conditions, dimmable energy saving lamps ESL and dimmable 230V LED lamps additionally dependant on the lamp electronics. Up to 3600W with LUD12 power additives at connections X1 and X2. Switching in zero crossing with soft-on and soft-off for lamp protection. Universal control voltage 8..230V UC, electrically isolated from the supply and switching voltage 230V. No minimum load required. PWM control with 10-24V DC at the PWM and GND connections. The set brightness level remains stored when the device is switched off (memory). In the event of a power failure, the switching position and the brightness level are saved and, if necessary, switched on when the supply voltage returns. Automatic electronic overload protection and over-temperature switch-off. With the upper % rotary switch, you can set the maximum brightness (fully dimmed). With the middle % rotary switch, you can set the minimum brightness (fully dimmed). The lower rotary switch sets the operating mode: On: Duration on with maximum brightness. Item 1 is AN AUTO setting and allows all types of lamps to be dimmed. Switch on and off with button on the device and/or button on +A1/-A2. Dimming with rotary knob. Item 2 is a comfort position for LED lamps, which cannot be dimmed far enough on AUTO (phase section) due to the design and therefore must be forced to phase angle. Switch on and off with button on the device and/or button on +A1/-A2. Dimming with rotary knob. Item 3 is a comfort position for energy-saving lamps, which must be switched on with an increased voltage due to their design, so that they can also be dimmed when cold and switched on again safely. Switch on and off with button on the device and/or button on +A1/-A2. Dimming with rotary knob. Item 4 is AN AUTO setting and allows all types of lamps to be dimmed. Switch on and off with switch at +A1/-A2. Dimming with rotary knob. Item 5 is a comfort position for LED lamps, which cannot be dimmed far enough on AUTO (phase section) due to the design and therefore must be forced to phase angle. Switch on and off with switch at +A1/-A2. Dimming with rotary knob. Item 6 is a comfort position for energy-saving lamps, which must be switched on with an increased voltage due to their design, so that they can also be dimmed when cold and switched on again safely. Switch on and off with switch at +A1/-A2. Dimming with rotary knob. Item 7 is AN AUTO setting and allows all types of lamps to be dimmed. Switching on/off and dimming with PWM control. Item 8 is a comfort position for LED lamps, which cannot be dimmed far enough on AUTO (phase section) due to the design and therefore must be forced to phase angle. Switching on/off and dimming with PWM control. Off: Duration off. The LED under the upper rotary switch lights up when the light is switched on.This text is machine translated.