DL-1CH-16A-DC12+ Eltako LED dimmer 1-channel Recess-mount Suspended ceiling
1-channel DALI LED dimmer for ceiling entry. Standby loss of only 0.12 watts. Suitable for controlling constant voltage LED modules (CV) with operating voltages from 12V to 48V. SW&Dim or SwitchDim2: Operation via 1 or 2 push-button inputs enables the control of brightness without DALI, alternatively corridor function for direct control with a motion detector. Dimming range 0.1%-100%. PWM-frequency switchable (122Hz/244Hz/488Hz/976Hz). Supply voltage 12V to 48V DC. Max. Connection current 16A. High efficiency. Configuration via PC software DALI cockpit and DALI USB interface. Operating modes: The output channel is controlled via a DALI address (Device Type 6). Alternatively, operation can be performed via one (SW&Dim) or two button inputs (SwitchDim2): SwD1,SW&Dim: Brightness. Short press: On/off. Long press: Dim. SwD2: Scene switch (short keystroke). If the SwD1 input is pressed for 2 minutes, the mode 'Corridor function' is changed. This operating mode remains active until the device is disconnected from the supply voltage (after PowerUp: Operation via SwD1/SwD2). Corridor function: Mode with integrated staircase automatic circuit (e.g.: For simple control with the relay contact of one or more motion detectors). When the input is activated, the maximum value is activated. After the input signal has dropped, the brightness remains at this value for the duration of the hold time before it is lowered to the intermediate value. After the hold time for the intermediate value has expired, the basic value of the brightness is returned. When the input is triggered again, the sequence starts from the front. The DALI Cockpit software can be used to configure the 1-channel LED dimmer. Both the ÂGruppenzugehoerigkeit and scene values and DALI parameters can be set (the displayed parameters correspond to the factory setting). Delivery status: Before the first address, the device can be controlled via the group addresses G0. This preset group assignment is deleted during addressing, after which any group assignment can be made in the DALI cockpit. By sending a DALI reset command, the values defined in the DALI standard are established.This text is machine translated.