Ansmann ALCT 6-24/2 1001-0016 1001-0016 Automatic charger 12 V 24 V 6 V 05 A 05 A 1 A 2 A 05 A 1 A
Intelligent and safe charging control even under frosty conditions!Through numerous features the ALCT 6-24/2 provides for a safe and gentle charging and guarantees an optimum performance and long life of lead-acid batteries. After successful contact with the pole terminals, the device automatically detects the voltage of the connected lead battery and indicates this via the corresponding LED on the display. Depending on the voltage, a charging current can be selected via the MODE button, whereby car batteries can be charged very quickly but also small motorcycle batteries can be charged very gently.For 6 V/12 V or 24 V lead-acid batteries with a capacity of 1.2 Ah - 80Ah and up to 2A charging currentThe charging currents are as follows: 0.5A at 6V, 12V, 24V / 1A at 12V, 24V / 2A at 12V. If no setting is made, charging takes place with the preset charging current of 0.5A. Lead-gel, lead-fleece and lead-acid in the voltage 6V, 12V, 24V are loadable.Refresh mode - total discharge of the battery excluded and gentle over winterThe charger automatically detects when the connected battery is deeply discharged and gently charges it by pulsating charging currents for 20 minutes until a sufficient basic voltage is reached for the normal charging process. If the battery is permanently connected to the charger during the winter, it detects a possible loss of capacity and then charges automatically. This prevents deep discharge. Batteries of motorcycle, motor boat, lawn mower etc. are so good over the winter and are ready to use whenever required.Cold Temp modeAt low temperatures below 5°C, the voltage level of the battery changes and the connected battery cannot be fully charged during normal charging. This can be avoided by selecting the COLD TEMP mode via the MODE button.Reverse polarity protection, overload protection, practical long cableIf the terminal clamps are swapped, the LED on the display lights up red. A long cable of 2.0m is particularly convenient and allows charges without extension cables.A special charging process, developed in-house, with charge current control and overload protection, automatically switches over to maintenance charging after full charging. This means that the battery is not overloaded and can remain connected to the charger for a longer period of time.The ALCT 6-24/2 is suitable for standby parallel operation, i.e. it can remain permanently connected to the battery and always keeps it full, even if the battery is simultaneously charged/discharged.This text is machine translated.